Lippert-components Hydraulic Through Frame Slideout Uživatelský manuál stáhnout pdf (Strana 11)

Rev: 07.09.2014

Page 11

Hydraulic Through Frame Slideout Owners Manual

GEAR PACK REPLACEMENT INSTRUCTIONS

SLIDEOUTS

In the event a gear pack needs to be replaced, follow these steps:

1. Run slideout room half way out.

2. Place a jack under the inner arm of the slideout.

3. Jack room up just enough to remove pressure off the gear pack.

4. Remove drive bolt from the cross shaft.

5. Remove bolts which hold the gear pack assembly in place on the outer rail.

6. Drop out the damaged gear pack.

7. Install the new gear pack.

8. Install bolts to hold gear pack assembly in place on the outer rail.

9. Install cross shaft and bolt.

10. Gear pack assembly does not need to be torqued down, only adequately and securely tightened.

Fig. 1

Gear Pack

Outer Rail

Mounting

Bolts

Gear Rack

Gear Packs

281331 2 x 2

140409 2 x 3, 3 x 3

122837 Standard 2.5 x 2.5

123356 Heavy Duty 2.5 x 2.5

140418 Embedded Rack

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Žádné komentáře

Lippert-components Hydraulic Through Frame Slideout Uživatelský manuál Strana 11